Serial GUI Control Panel
Control up to 4 Serial Ports
               

• 1. Scan: Scan for available UART devices.
• 2. Launch cutecom together when starting Serial Port.
• 3. Port number in system
• 4. Baud Rate choose
• 5.6.7.  UART Port  Information:  Port Address 0x48,0x49, 0x4c, 0x4d

              Chip Address Location, Channel Number ( 1 / 2 ), TX and RX receive counter,

              and Serial port Location /dev/pts/X

• 8. RS485 : Enable RS485 in this Port
• 9. Start : Start UART port

Also provided is a terminal command mode to activate serial ports through a terminal / ssh.
You can also activate a serial port on boot up with the provided software.
Commands for starting the serial ports via command line;
./Pi232 -a ADDR -c CHANNEL -b BAUD -s DEVPTS

./Pi485 -a ADDR -c CHANNEL -b BAUD -s DEVPTS
ADDR = Address of Serial Port e.g. 0x48, 0x49, 0x4C, and 0x4D
CHANNEL = Channel of serial Port ( 1 / 2 )
BAUD = Baud Rate for the Serial Port
DEVPTS = PICOM Service Number ( Will direct the filename to /dev/picomX where X = your number )
For example, To start a serial port from 0x49, on channel 2 with 115200 Baud run the following;
./Pi232 -a 0x4d -c 2 -b 115200 -s 1
This will activate the serial port and then set /dev/picom1 to your serial port location /dev/pts/X

./Pi485 -a 0x4c -c 2 -b 115200 -s 1
This will activate the serial port and then set /dev/picom1 to your serial port location /dev/pts/X

Enable RS232 in command mode 

Enable RS485 in command mode

1. device ->   /dev/pts/1       

2 . Baud rate  à 38400

3. click Open device  

4. input AT command (HC-05 blutetooth module)

5. screen will show Bluetooth module response  

type "top" in terminal 

Enable 4 Port RS232 x2 - RS485 x2 

 You will see 2 x Pi232 & 2 x Pi485 run in system